DUROFLOOR-BI is a two-component, colorless epoxy system with solvents. Thanks to its low viscosity, it can penetrate deep into the substrate and fill pores and hairline cracks. The impregnated surfaces become stable and durable, resistant to abrasion, frost and chemicals, especially to waste, mineral oils and petroleum products. Certified according to EN 13813 and classified as SR-B2,0. CE marked.
DUROFLOOR-BI is used for in-depth impregnation treatment of cement-based substrates, e.g. old and new concrete, cement screeds or plaster, etc. Suitable for floors in car parks, warehouses, laboratoires, industries, gas stations, auto repair shops, etc. Also used as a primer for EPOXYCOAT, EPOXYCOAT-VSF and EPOXYCOAT-S epoxy coatings.
Substrate preparation
The flooring surface should be:
- Dry and stable
- Free of materials that might impair bonding, e.g. dust, loose particles, grease, etc.
- Protected from negative water pressure.
Application – Consumption
DUROFLOOR-BI is applied with a roller, brush or spray in one or two layers, depending on the absorbency of the substrate. The second layer is applied 15 min after the first one. DUROFLOOR – BI may be applied on new concrete because curing is not disturbed. It may also be applied to slightly wet substrates (moisture content up to 6%). In both cases a low impregnation depth is achieved. If an impregnation depth of about 5 mm into concrete is required, moisture content should be less than 3%.
