DUROFLOOR-CV

DUROFLOOR-CV is a two-component, colored epoxy system with solvents, offering strong adhesion to the substrate and good conductivity that prevents the accumulation of static electricity on surfaces. It has a conductivity resistance lower than 10 4Ohm. Certified according to EN 13813 and classified as SR-B2,0. CE marked.
DUROFLOOR-CV is used as an intermediate layer of the epoxy system DUROFLOOR-C, to assure uniform conductivity on the whole floor surface.

Mixing of components
Components A (resin) and B (hardener) are packaged in two separate containers, having the correct predetermined mixing ratio by weight. The entire contents of component B is added to component A. Mixing of the 2 components should take place for abour 5 minutes, using a low-revolution mixer (300 rpm). It is important to stir the mixture thoroughly near the sides and bottom of the container to achieve uniform dispersion of the hardener.

Application – Consumption
DUROFLOOR-CV is applied within 24 hours after priming with DUROFLOOR-PSF or DUROPRIMER epoxy primer and after the primer has hardened. First, the special self-adhesive copper tapes (conductors) should be installed on the floor in a grid formation of at most 5 x 5 m mesh and connected to the ground through a perimetric cable. Afterwards, DUROFLOOR-CV is applied by roller in a thin layer.
Consumption: approx. 200 g/m2.
DUROFLOOR-C should be applied within the following 24 hours.

DUROFLOOR-CV is supplied in packages (A+B) of 8 kg, with components A and B having fixed weight proportions.
12 months from date of production if stored in original sealed packaging, in areas protected from humidity and direct sunlight. Recommended storage temperature between +5 oC and +35 oC.

  • The workability of epoxy materials is affected by their temperature. The ideal temperature of application is between +15 oC and +25 oC so that the product will be easy to use and cure as prescribed. Room temperature below +15 oC will expand the curing time and temperature above +30 will accelerate the curing time. In winter a mild preheating of the product is recommended, while in summer to store the materials in a cool room before the application.
  • Bonding between successive layers may be severely affected by the intervention moisture or dirt.
  • After hardening, DUROFLOOR-CV is totally safe for health.
  • Epoxy layers should be protected from moisture for 4-6 hours after application. Moisture may whiten the surface or/and make it sticky. It may also disturb hardening. Faded or sticky layers in parts of the surface should be removed by grinding or milling and laid again.
  • In case recoat time is longer than expected or old floors are to be laid again, the surface should be thoroughly cleaned and ground before application of the new layer.
  • Please consult the directions for safe use and precautions wrriten on the packaging before use.
null

Surface: Concrete, plaster, cement

null

Application: Roller, brush, spray