EPOMAX-ANCHOR is a two-component polyester-based anchoring adhesive. It does not contain solvent and styrene and has no shrinkage behavior. EPOMAX-ANCHOR can be used as a fast-curing anchoring adhesive for reinforced bars, threaded rods, anchor bolts, etc. It can be used to install these fixtures into concrete, solid rock, hollow and solid masonry, etc.

Installation to concrete or solid stone
Drill correct diameter hole to the recommended depth. Then clean the hole thoroughly with a nylon brush and remove any loose particles using compressed air, hand pump, etc. Screw the mixer to the cartridge, after that, attach the mixer nozzle to the end of the cartridge and insert the cartridge into the applicator gun. Afterwards squeeze out to discard approximately 15 ml of compound, this quantity is not used. Starting from the back end, fill hole completely with the resin. Push anchor up to base of hole whilst turning it slightly. A visual check of resinfilling is necessary. Allow the material to cure before attaching fixings and applying loads. Be consulted the relative table of curing times for EPOMAX-ANCHOR.

Installation to hollow bricks and artificial stone 
Drill hole without percussion drill. Then remove any loose particles using compressed air, hand pump, etc. Screw the mixer to the cartridge, after that, attach the mixer nozzle to the end of the cartridge and insert the cartridge into the applicator gun. Afterwards squeeze out to discard approximately 15 ml of compound, this quantity in not used. Insert the perforated sleeve in the hole. Starting from the back end, fill the perforated sleeve with resin. Afterwards, push anchor up to the base of the sleeve whilst turning it slightly. Allow the material to cure before attaching fixings and applying loads. Be consulted the relative table of curing times for EPOMAX-Anchor.