ISOMAT BI-100

Water-based polymer emulsion with high penetration ability. When applied on concrete floors or cement screeds, it seals and dustproofs their surface. ISOMAT BI-100 can also be used as a surface hardener for crumbled floorings and surfaces in order to increase their strength and wear resistance. Moreover, it eliminates the permeability of floorings and makes them easy to clean. ISOMAT BI-100 isused on concrete floors or cement screeds in places such as basements, warehouses, light traffic parking lots etc. Suitable for indoor and outdoor use.

Substrate preparation

The surface must be dry and free of dust, grease, dirt etc. For better impregnation of ISOMAT BI-100, the surface should be prepared by grinding and cleaning of dust.

Application

ISOMAT BI-100 is thoroughly stirred and uniformly applied on the substrate by brush, roller or spraying, until full impregnation. Forvery absorbent surfaces, it is usually required to apply a second layer, after the first one has dried.

  • During application, the ambient and substrate temperature shuld be between +5 oC and +30 oC.
  • The successive layer may be applied as soon as ISOMAT BI-100 has completely dried.
  • ISOMAT BI-100 is almost transparent after drying. It should be tested on the surface before the application, as it may alter the appearance of the surface.
  • ISOMAT BI-100 is not suitable for permanent immersion to water. Uneven surfaces should be properly treated with a sutable repairing material. 
null

Surface: Concrete, cement

null

Application: Brush, roller or spray