ISOMAT BI-100

Water-based polymer emulsion with high penetration ability. When applied on concrete floors or cement screeds, it seals and dustproofs their surface. ISOMAT BI-100 can also be used as a surface hardener for crumbled flooring and surfaces in order to increase their strength and wear resistance. Moreover, it eliminates the permeability of flooring and makes them easy to clean.
ISOMAT BI-100 is used on concrete floors or cement screeds in places such as basement, warehouses, light traffic parking lots etc. Suitable for indoor and outdoor use.

Substrate preparation
The surface must be dry and free of dust, grease, dirt etc. For better impregnation of ISOMAT BI-100, the surface should be prepared by gringing and cleaning of dust.

Application
ISOMAT BI-100 is thoroughly stirred and uniformly applied on the substrate by brush, roller or spraying, until full impregnation. For very absorbent surfaces, it is usually required to apply a second layer, after the first one has dried.

  • During application, the ambient and substrate temperature should be between +5 oC and +30 oC.
  • The successive layer may be applied as soon as ISOMAT BI-100 has completely dried.
  • ISOMAT BI-100 is almost transparent after drying. It should be tested on the surface before the application, as it may alter the appearance of the surface.
  • ISOMAT BI-100 is not suitable for permanent immersion to water. Uneven surfaces should be properly treated with a suitable repairing material. Consult the Technical Support Department.
null

Surface: Concrete, cement

null

Application: brush, roller or spraying