FIBRANgeo R-040 roll can be produced with the facing AL (Aluminum foil reinforced with fibreglass net), YM (Black non-woven fibreglass fleece) or XA (Kraft paper).
Rolls designed for thermal insulation, fire resistance and sound insulation applications:
- Dry-construction ceiling, non-perforated suspended ceiling
- Attic ceiling lining
- Between roof’s timber or metal joists
- Between floor timber rafters or joists (no load on stonewool)
Advantages
- Excellent thermal insulation
- Non-combstible material with excellent fire resistance
- Excellent sound absorption and sound reduction
- Open hive structure material with very low water vapour diffusion resistance that enchances the building element’s breathability
- Excellent dimensional stability and durability
- Water repellent and non-hygroscopic
- Easy to handle, cut and install
- Natural, inorganic, odourless, chemically inert (practically neautral PH)
- Recyclable, friendly to the enviroment and to the end user.
Certification
FIBRANgeo R-040 stonewool insulation products have been certified according to European Norms EN 13162 and EN 13172 and hold the CE marking that derives from the Declaration of Performance. All FIBRANgeo stonewool insulation products meet the quality and safety requirements of the European Standards and comply with the European Regulations 305/2011 (CPR).
FIBRANgeo products must be protected from getting wet before and on their application. If part of the product gets wet, it must be dried before installation. Stonewool dries quickly and its insulating properties remain unchanged after drying. Packaging should be removed carefully just before the installation. Working areas should be kept clean. Unnecessary or extensive contact of the skin and eyes with product’s off-cuts, fibres and dust should be avoided, and protective wear should be used (gloves, goggles, hats). Products with facing AL, AX, YM and YA are not suggested for application with service temperature on the surface more than 90 oC while those with surface XA are not suggested for more than 66 oC. Sufficient ventilation of the working areas should be ensured, whilst power cutting tools should always be equipped or supplemented with a mechanical system of dust intake.